Rooms are hard on speakers, especially in the bass: a few big peaks can make a system sound boomy no matter how good the speakers are. Room EQ measures each speaker's response with a microphone at the listening position and builds a set of peaking filters per speaker that even it out — mostly cuts, applied where the room is causing trouble.
It's made for a measurement mic like the Dayton Audio iMM-6: load the mic's calibration file (download it from Dayton's site with the serial number on the mic — use the 90° file, since the mic points at the ceiling) and it's kept per mic and applied to every measurement. Choose a Harman-style in-room target (gently rising bass, treble falling 1 dB an octave) or flat, how high to correct (300 Hz, 1 kHz or full range), and how much boost to allow.
The EQ is written to Voicemeeter's per-channel bus EQ, or to Equalizer APO for any other device, so it stays applied with nothing running. Then "Hear the difference" plays your own music and flips the new EQ on and off every few seconds, so you can decide whether to keep it.
Each speaker gets its own peaking filters, measured where you sit.
Load your Dayton Audio iMM-6 (or other) calibration file; it's remembered per mic.
Harman-style room curve or flat, with broad-shape cuts limited so one mic position can't overcorrect.
Correct up to 300 Hz, 1 kHz (recommended) or 16 kHz, with 0 / 3 / 6 dB maximum boost.
Works through Voicemeeter's bus EQ, or Equalizer APO for any other device.
A/B the new EQ against your own music, switching every few seconds, before you keep it.